Line 236: |
Line 236: |
| *Measure the amount of fabric you would need | | *Measure the amount of fabric you would need |
| *We will use the laser cutter to cut out the fabric, you can use Inkscape to make the perforations. | | *We will use the laser cutter to cut out the fabric, you can use Inkscape to make the perforations. |
| + | [[File: Perforations.png|center|200x500 px| Perforations]] |
| + | <div class="center" style="width: auto; margin-left: auto; margin-right: auto;">Figure 10. Perforations Inkscape design </div> |
| + | |
| + | Note: This design was used to maximize cohesion. |
| + | * Iron your fabric and lay it on a piece of MDF. Tape it securely into place. |
| + | |
| + | [[File: Fabric on board in laser cutter.png|center|200x500 px| Fabric on board in laser cutter]] |
| + | <div class="center" style="width: auto; margin-left: auto; margin-right: auto;">Figure 11. Fabric on board in laser cutter </div> |
| + | |
| + | * Configure the properties as follows: |
| + | Note: Laser Cutter used: Epilog Mini |
| + | The properties depend on the fabric used: |
| + | Vector Settings: |
| + | Speed: 100 % |
| + | Power: 10 % |
| + | Frequency: 150 Hz |
| + | |
| + | *Begin cut: |
| + | [[File: Fabric on board in laser cutter.png|center|200x500 px| Fabric on board in laser cutter]] |
| + | <div class="center" style="width: auto; margin-left: auto; margin-right: auto;">Figure 11. Fabric on board in laser cutter </div> |
| + | |
| + | |
| + | The different configurations will vary depending on the printer, the material or the type of fabric you are using for your project. |
| + | Yet, the overall process for 3D printing on fabric remains similar, that is, you should incorporate your fabric in between the two stages of printing. |
| + | |
| + | |
| + | |
| + | |
| | | |
| | | |
| | | |
| == References == | | == References == |