MakerRepo Administrators, MakerRepo Staff
531
edits
Changes
Jump to navigation
Jump to search
Line 175:
Line 175: − +
Digital technologies/3D printing/3D printing- Intermediate (view source)
Revision as of 15:18, 4 June 2024
, 4 June→Bed Levelling, Filament Change
<youtube>9v1w_dmpLu0</youtube>
<youtube>9v1w_dmpLu0</youtube>
To change the filament on an Ultimaker 2+ printer, go to Material→Change in the printer’s user interface and follow the onscreen instructions. If ever the filament has almost run out, or if you desire to change the color of a print midway, you may navigate to Pause→Change Material and following the onscreen instructions. If changing mid-way, it is recommended that the older filament be completely purged from the nozzle using the new filament. Otherwise, the result will not be good. Again, within the Makerspace, this should only be done by the staff working.
To change the filament on an Ultimaker 2+ printer, go to Material→Change in the printer’s user interface and follow the onscreen instructions. If ever the filament has almost run out, or if you desire to change the color of a print midway, you may navigate to Pause→Change Material and following the onscreen instructions. If changing mid-way, it is recommended that the older filament be completely purged from the nozzle using the new filament. Otherwise, the result will not be good. Again, within the Makerspace, this should only be done by the staff working.
==[[Digital technologies/3D printing/3D printing- Intermediate/Selecting Nozzle Sizes|Selecting Nozzle Sizes]]==
==[[Digital technologies/3D printing/3D printing- Intermediate/Selecting Nozzle Sizes|Selecting Nozzle Sizes]]==