Digital technologies/3D printing/3D printing- Beginner/FDM Printer Components

Extruder and Nozzle (CAUTION: HOT!)

The extruder heats and pulls partially melted filament into the nozzle. During a print, the extruder and nozzle will heat up to over 210°C, so exercise caution around it. The location of the printer nozzle and extruder is controlled on an axis system (typically) made up of belts and gears. This assembly can be moved while the printer is idle by gently pulling on the extruder/nozzle assembly, being careful as parts of this assembly can be extremely hot even after a print has finished. If the printer is printing, or has recently been printing, the motors will still be engaged. Set the printer to idle and wait a few minutes, or power off the machine to disengage the motor lock.

Build Plate (CAUTION: HOT!)

The build surface is where the printed part is placed on. On most of the Makerspace printers the build plate is heated to 60°C (and can go as high as 110°C) during printing, so exercise caution around it. The plate can be raised or lowered while the printer is idle by going to Maintenance→Advanced→Raise/Lower Build Plate.

Filament Spool

The filament spool can be found attached to the back of the printer. The spool is essentially a filament roll. As the printer uses up the filament, the spool unrolls. Before printing, it is a good habit to check filament levels on the printer. You may find steps for replacing the filament in the intermediate page.

An overview of the Ultimaker 2 parts. Most FDM printers contain the same components.