MakerRepo Staff, MakerRepo Volunteers
872
edits
Changes
Jump to navigation
Jump to search
Line 6:
Line 6: − +
Digital technologies/Laser cutting/Rotary Laser Engraving (view source)
Revision as of 17:54, 29 August 2024
, 29 August→Setting Up the Tool
# To do so, simply lift up all the rulers
# To do so, simply lift up all the rulers
# Lift up the bed to take it out. The bed is not heavy, if you happen to struggle to take it out, there is probably an obstruction in the way. At the Makerspace, ask a staff member to assist you if possible.
# Lift up the bed to take it out. The bed is not heavy, if you happen to struggle to take it out, there is probably an obstruction in the way. At the Makerspace, ask a staff member to assist you if possible.
# Remove the crumb trey by opening the front magnetic door of the laser and then sliding it out.
# Remove the crumb tray by opening the front magnetic door of the laser and then sliding it out.
# Remove the cross section bar.
# Remove the cross section bar.
# There are pins underneath the tool and also a plug-in connection to connect on the laser
# There are pins underneath the tool and also a plug-in connection to connect on the laser