Line 185: |
Line 185: |
| * To adjust level: At the Ultimaker printer go to Maintenance -> Build plate and follow the instructions given. | | * To adjust level: At the Ultimaker printer go to Maintenance -> Build plate and follow the instructions given. |
| | | |
| + | ====== Calibrating the build-plate: ====== |
| + | Calibrating the plate may be necessary when dealing with specialty filament, more information can be found on the following [[Digital technologies/3D printing/3D printing- Intermediate/Bed Levelling, Filament Change|link.]] |
| + | |
| + | === Gathering materials: === |
| + | Before starting your print, ensure that you have the following materials: |
| + | |
| + | * Fabric |
| + | * Tape |
| + | * Scissors |
| + | * Ruler |
| + | |
| + | After gathering your materials, |
| + | |
| + | * Measure out the amount of fabric you would need and cut it out. |
| + | |
| + | Note: Your fabric should be smaller than the print area. |
| + | |
| + | * The fabrics used were tulle and a woven fabric. |
| + | |
| + | == Starting your print == |
| + | Note that the printing will be in two stages. |
| + | |
| + | The first stage will be before the fabric is embodied in the 3D printed part and the second stage will be after its incorporation. |
| + | |
| + | * Save your model and bring it to the printer. |
| + | * Switch on the printer and do the necessary configuration depending on the material you are using. |
| + | * Begin print. |
| + | |
| + | Let it print the first two layers of your model as shown below: |
| | | |
| | | |
− | Calibrating the plate may be necessary when dealing with specialty filament, more information can be found on the following [[Digital technologies/3D printing/3D printing- Intermediate/Bed Levelling, Filament Change|link]]
| |
| | | |
| == References == | | == References == |