MakerRepo Staff
74
edits
Changes
Jump to navigation
Jump to search
Line 22:
Line 22: − + +
Digital technologies/Laser cutting/Rotary Laser Engraving (view source)
Revision as of 20:39, 1 August 2024
, 1 August→Top Surface Leveling
==== Top Surface Leveling ====
==== Top Surface Leveling ====
If you have a conic part, you still need to have a flat top surface. To get the perfectly flat top surface, you will have to manually level the bed to the highest point of your part, which should be the left side. Then, while keeping your focusing tool on, you can move the laser to the right hand side and adjust the roller height until the part touches the focusing tool. Go back to the left hand side to make sure your focus didn't change at that point and you should now have a good leveling. You can repeat the steps if you are not satisfied. You can also use a bubble level to check if the top surface has the same level as the gantry.
If you have a conic part, you still need to have a flat top surface. To get the perfectly flat top surface, you will have to manually level the bed to the highest point of your part, which should be the left side. Then, while keeping your focusing tool on, you can move the laser to the right hand side and adjust the roller height until the part touches the focusing tool. Go back to the left hand side to make sure your focus didn't change and you should now have a good leveling. You can repeat the steps if you are not satisfied. You can also use a bubble level to check if the top surface has the same level as the gantry.
[[File:Leveling Method.png|center|thumb|479x479px|You can see that the right hand side is a little lower. You can raise it if you would like, but the difference in results for such a small difference will probably not be visible to the naked eye.]]
==== Tubing and Light Parts ====
==== Tubing and Light Parts ====