MakerRepo Staff, MakerRepo Volunteers
872
edits
Changes
Jump to navigation
Jump to search
Line 42:
Line 42: − +
Digital technologies/Laser cutting/Laser cutting- Beginner/How to Laser Cut in the Makerspace/Zing (view source)
Revision as of 20:10, 19 June 2024
, 19 June→Properties
==Properties==
==Properties==
The other way for the user to interact with the laser cutter is by setting up the laser properties for a cut.
The other way for the user to interact with the laser cutter is by setting up the laser properties for a cut.
[[File:Properties Epilog Zing.png|thumb|Properties]]
[[File:Properties Epilog Zing.png|center|Properties]]
#'''Resolution:''' The print resolution can set from 100 to 1000 Dots per inch (DPI), the higher the DPI the more time it takes for laser cutter to complete the job. Usually, the print resolution is set at 500 DPI, the settings on the laptop will demonstrate the same.
#'''Resolution:''' The print resolution can set from 100 to 1000 Dots per inch (DPI), the higher the DPI the more time it takes for laser cutter to complete the job. Usually, the print resolution is set at 500 DPI, the settings on the laptop will demonstrate the same.
#'''Centre Engraving:''' It allows you to define the centre of the job.
#'''Centre Engraving:''' It allows you to define the centre of the job.