Changes

===LED===

===LED===

A Light Emitting Diode, or LED, is a semiconductor device that lights up when an electric current passes through it. They come in many different colors and shapes, and are very versatile. LEDs are diodes, which means that current flows through the element in only one way, from the positive to the negative end. On an LED, the cathode end can be identified by either a flat edge on the body, or as the shorter leg. As such, the anode is the other end (the longer leg on the LED).

A Light Emitting Diode, or LED, is a semiconductor device that lights up when an electric current passes through it. They come in many different colors and shapes, and are very versatile. LEDs are diodes, which means that current flows through the element in only one way, from the positive to the negative end. On an LED, the cathode end can be identified by either a flat edge on the body, or as the shorter leg. As such, the anode is the other end (the longer leg on the LED)

[[File:LED - 1.png|center|thumb|198x198px|(Source: https://create.arduino.cc/projecthub/rowan07/make-a-simple-led-circuit-ce8308)]]

===Pushbutton===

===Pushbutton===

A pushbutton is an electronic switch component that completes the circuit only when pressed. In an electric circuit, electricity needs to flow continuously through the circuit in order for all parts to function. The pushbutton interrupts this circuit and forms a gap, so that electricity doesn't flow to the other side of the pushbutton. When the pushbutton is pressed. a small spring is activated that is made of conducting material so that electricity flows through the spring to the other side of the pushbutton.

A pushbutton is an electronic switch component that completes the circuit only when pressed. In an electric circuit, electricity needs to flow continuously through the circuit in order for all parts to function. The pushbutton interrupts this circuit and forms a gap, so that electricity doesn't flow to the other side of the pushbutton. When the pushbutton is pressed. a small spring is activated that is made of conducting material so that electricity flows through the spring to the other side of the pushbutton.

===Resistor===

===Resistor===

A resistor is an electrical component which creates electrical impedance, or resistance to current flow. The amount of resistance a resistor provides can be read from the bands of color on the resistor, which are read left to right. For four bands resistors, the first and second bands represent digits, while the third band represents a multiplier to multiply the digits of the first and second band by. The fourth band is the tolerance, it represents how much the resistor may deviate from the value indicated by the bands. The value of the resistor can also be determined using the ohmic function of a multimeter. Resistors are often used in series with components to reduce the amount of current flowing through a circuit, often to protect components rated for lower current amounts. Pull-up and pull-down resistors are used to bias an input on the Arduino to be either HIGH or LOW respectively. This needs to be done as the resting level of the input isn’t necessarily 0. This is especially useful when working with sensors that have an analog output.

A resistor is an electrical component which creates electrical impedance, or resistance to current flow. The amount of resistance a resistor provides can be read from the bands of color on the resistor, which are read left to right. For four bands resistors, the first and second bands represent digits, while the third band represents a multiplier to multiply the digits of the first and second band by. The fourth band is the tolerance, it represents how much the resistor may deviate from the value indicated by the bands. The value of the resistor can also be determined using the ohmic function of a multimeter. Resistors are often used in series with components to reduce the amount of current flowing through a circuit, often to protect components rated for lower current amounts. Pull-up and pull-down resistors are used to bias an input on the Arduino to be either HIGH or LOW respectively. This needs to be done as the resting level of the input isn’t necessarily 0. This is especially useful when working with sensors that have an analog output.

===Introduction to Sensors===

===Introduction to Sensors===