Miter Saw

PERSONAL PROTECTIVE EQUIPMENT (PPE)

• Safety glasses (mandatory)
• Hearing protection
• Dust mask or respirator if cutting MDF or dusty material
• No gloves, loose clothing, or jewelry
• Tie back long hair

GENERAL SAFETY RULES

• Only trained users may operate this tool
• Inspect blade for damage before use
• Keep hands at least 6 inches away from the blade
• Use clamps or a stop block for small pieces
• Never cut freehand – material must rest firmly against the fence
• Wait for the blade to stop fully before lifting it

MACHINE SETUP

• Ensure the saw is secured to the bench or stand
• Check that the work area is clear of debris
• Confirm the saw is unplugged before adjusting
• Adjust miter and bevel angles as required
• Ensure blade guard is functioning properly

OPERATING STEPS

• Plug in the saw and confirm blade is correct for material
• Mark your cut line on the workpiece
• Place workpiece flat against the fence and table
• Use clamps for narrow or short pieces
• Lower the saw head to align the blade with the cut line
• Power on and allow the blade to reach full speed
• Slowly lower the blade through the material
• Hold until the blade has completely stopped
• Raise the saw and remove the cut piece

CLEANUP & SHUTDOWN

• Unplug the saw when finished
• Brush away dust and debris from the saw and table
• Return clamps and stop blocks to storage
• Report any damage or dull blades to staff

🚫LIMITATIONS🚫

• Do not rip cut (with the grain)
• Avoid cutting very small pieces (<6” long without a jig)
• Use only appropriate blades for wood or composite materials
• Do not cut metal or masonry