Changes

Digital technologies/3D printing/3D printing- Intermediate (view source)

Revision as of 00:09, 23 June 2022

1,168 bytes added , 00:09, 23 June 2022

→‎Custom Slicer Settings as an Intermediate User

Line 39: Line 39:

==[[Digital technologies/3D printing/3D printing- Intermediate/Custom Slicer Settings|Custom Slicer Settings as an Intermediate User]]==

This section is under construction. If you want more information on the print settings available in Cura, check out [https://support.ultimaker.com/hc/en-us/sections/360003548619-Print-settings the Cura documentation on Ultimaker's website].

+

===Print Speed===

+

The ways in which the print speed will affect the final print are not always obvious. If the print speed is too high, the printer might not be able to dispense enough material through its nozzle per unit of time to fill the desired volume with the required amount of material. This can lead to bad adhesion between layers or even a complete lack of adhesion to layers. The ratio of layer height to layer speed (i.e.: material outflow through the nozzle) should therefore always be considered when FDM printing (the exact subject though being more of an intermediate subject). When making parts that will bear loads, print speeds are increasingly important as layer adhesion becomes an important factor in the strength of the final part, so much so that parts may be annealed (uniformly re-heated through a controlled process) to obtain better properties across layers.<ref>Agnieszka Szust, Grzegorz Adamski, ''Using thermal annealing and salt remelting to increase tensile properties of 3D FDM prints'', Engineering Failure Analysis, Volume 132, 2022, 105932, ISSN 1350-6307, <nowiki>https://doi.org/10.1016/j.engfailanal.2021.105932</nowiki>.</ref>

==[[Digital technologies/3D printing/3D printing- Intermediate/Dual Extrusion|Dual extrusion]]==

<br />

Strem078

295

edits