295
edits
Changes
Digital technologies/3D printing/3D printing- Beginner (view source)
Revision as of 20:07, 16 May 2022
, 20:07, 16 May 2022→FDM Printer Components
===Filament Spool===
===Filament Spool===
The filament spool can be found attached to the back of the printer. The spool is essentially a filament roll. As the printer uses up the filament, the spool unrolls. Before printing, it is a good habit to check filament levels on the printer. You may find steps for replacing the filament [[Digital technologies/3D printing/3D printing- Intermediate|in the intermediate page]].
The filament spool can be found attached to the back of the printer. The spool is essentially a filament roll. As the printer uses up the filament, the spool unrolls. Before printing, it is a good habit to check filament levels on the printer. You may find steps for replacing the filament [[Digital technologies/3D printing/3D printing- Intermediate|in the intermediate page]].
[[File:Ultimaker2+ Overview.PNG|center|thumb|1500x1500px|An overview of the Ultimaker 2 parts. Most FDM printers contain the same components.<ref>Modified from Ultimaker B.V. ''Ultimaker 2 User Manual''. Consulted on 2022/05/16 at https://support.ultimaker.com/hc/en-us/articles/360011955399-The-Ultimaker-2-user-manual</ref>]]
==[[Digital technologies/3D printing/3D printing- Beginner/3D printing in our Makerspace|3D printing in our Makerspace]]==
==[[Digital technologies/3D printing/3D printing- Beginner/3D printing in our Makerspace|3D printing in our Makerspace]]==
At the uOttawa Makerspace we have several different types (brands) of printers. When 3D printing in our Makerspace, you will encounter either the Ultimakers, MakerBots, or Dremels. In general, at a high level, the process for 3D printing is always the same. Typically, 3D printing on a hobbyist level is an iterative process in which you may have to tweak your models for the printer you are using. The following flowchart is a generalized yet important view of the typical workflow for 3D printing in the Makerspace.
At the uOttawa Makerspace we have several different types (brands) of printers. When 3D printing in our Makerspace, you will encounter either the Ultimakers, MakerBots, or Dremels. In general, at a high level, the process for 3D printing is always the same. Typically, 3D printing on a hobbyist level is an iterative process in which you may have to tweak your models for the printer you are using. The following flowchart is a generalized yet important view of the typical workflow for 3D printing in the Makerspace.