295
edits
Changes
Digital technologies/3D printing/3D printing- Beginner (view source)
Revision as of 19:08, 6 May 2022
, 19:08, 6 May 2022→Start the print
#Turn on the printer. There is an on/off switch located at the back, on the left hand side of the Ultimaker. This is also a good time to make sure that there is sufficient filament loaded into the printer.
#Turn on the printer. There is an on/off switch located at the back, on the left hand side of the Ultimaker. This is also a good time to make sure that there is sufficient filament loaded into the printer.
#Using the knob, select print. To “select” you simply press on the knob. This will take you to the SD card page, scroll through the files and select yours. Usually the most recent files are found at the bottom of the list. Selecting the file should start your print.
#Using the knob, select print. To “select” you simply press on the knob. This will take you to the SD card page, scroll through the files and select yours. Usually the most recent files are found at the bottom of the list. Selecting the file should start your print.
#We ask that you remain with your print for the first few layers. If you print fails and you are not there to tend to it, we will
##Be slightly annoyed as failed prints can damage the printers;
##Remove your print and free up the printer for someone else.
==[[Digital technologies/3D printing/3D printing- Beginner/Choosing your Slicer Settings as a Beginner|Choosing your Slicer Settings as a Beginner]]==
==[[Digital technologies/3D printing/3D printing- Beginner/Choosing your Slicer Settings as a Beginner|Choosing your Slicer Settings as a Beginner]]==