Changes

Digital technologies/3D printing/3D modeling- Beginner (view source)

Revision as of 15:22, 16 August 2021

977 bytes added , 15:22, 16 August 2021

m

→‎Splash Page (Designs & Projects)

Line 4: Line 4:

==[[Digital technologies/3D printing/3D modeling- Beginner/TinkerCAD Layout|TinkerCAD Layout]]==

−

===Splash Page (Projects)===

+

===Splash Page (Designs & Projects)===

−

~~<br />~~

+

The TinkerCAD splash page is very simple. On the left, you may switch design categories. This is necessary because TinkerCAD allows design of electronics circuitry and code as well as 3D modeling! For this wiki page, the relevant mode is 3D Design. On the centre of your page, you will find all your designs. It is recommended that you do not forget altogether about the navigation on the left, since chances are that you will want to create a project at some point, that will include all three design categories, for which we recommend you create a project in TinkerCAD, which can hold all design categories. This will help with keeping your workspace organised.

−

===~~Design Page (~~CAD Modeling)===

+

If you want to create a new 3D model, click 'Create New Design' in the main section of the page. If you wish to modify a 3D model, click on the model on the main section, and then click 'Tinker this' to access the CAD Modeling page.

−

~~<br />~~

+

===CAD Modeling===

+

The design page has quite a few sections and buttons, but it all remains quite straightforward.

==[[Digital technologies/3D printing/3D modeling- Beginner/Buttons on the Dashboard|Buttons on the Dashboard]]==

Strem078

295

edits