295
edits
Changes
Digital technologies/3D printing/3D printing- Beginner (view source)
Revision as of 19:10, 3 August 2021
, 19:10, 3 August 2021→Troubleshooting a failing print
|Warping
|Warping
| rowspan="2" |Not enough/too much model base surface contact to the print bed
| rowspan="2" |Not enough/too much model base surface contact to the print bed
|Using a brim or a raft (adhesion)<sup>*</sup>
|Use a brim or a raft (adhesion)<sup>*</sup>
|-
|-
| rowspan="2" |Bad adhesion
| rowspan="2" |Bad adhesion
|Using a brim or a raft (adhesion)
|Use a brim or a raft (adhesion)
|-
|-
|Uneven print bed/Bed too far from nozzle at initial layer
|Uneven print bed/Bed too far from nozzle at initial layer
|Relevelling buildplate
|Relevel the buildplate
|-
|-
| rowspan="2" |No extrusion
| rowspan="2" |No extrusion