MakerRepo Staff, MakerRepo Volunteers
872
edits
Changes
Digital technologies/Textiles/3D printing on Fabric (view source)
Revision as of 19:02, 9 August 2024
, 9 August→References
* To adjust level: At the Ultimaker printer go to Maintenance -> Build plate and follow the instructions given.
* To adjust level: At the Ultimaker printer go to Maintenance -> Build plate and follow the instructions given.
====== Calibrating the build-plate: ======
Calibrating the plate may be necessary when dealing with specialty filament, more information can be found on the following [[Digital technologies/3D printing/3D printing- Intermediate/Bed Levelling, Filament Change|link.]]
=== Gathering materials: ===
Before starting your print, ensure that you have the following materials:
* Fabric
* Tape
* Scissors
* Ruler
After gathering your materials,
* Measure out the amount of fabric you would need and cut it out.
Note: Your fabric should be smaller than the print area.
* The fabrics used were tulle and a woven fabric.
== Starting your print ==
Note that the printing will be in two stages.
The first stage will be before the fabric is embodied in the 3D printed part and the second stage will be after its incorporation.
* Save your model and bring it to the printer.
* Switch on the printer and do the necessary configuration depending on the material you are using.
* Begin print.
Let it print the first two layers of your model as shown below:
== References ==
== References ==