MakerRepo Staff, MakerRepo Volunteers
872
edits
Changes
Digital technologies/Laser cutting/Laser cutting- Beginner/How to Laser Cut in the Makerspace/Zing (view source)
Revision as of 18:12, 13 June 2024
, 13 June→Control Panel[2]
#'''Config(9):''' Access to the calibration settings.
#'''Config(9):''' Access to the calibration settings.
#'''Data:''' This light will illuminate when data is being passed to the laser, useful when checking if your computer is connected to the laser cutter.
#'''Data:''' This light will illuminate when data is being passed to the laser, useful when checking if your computer is connected to the laser cutter.
#'''∆/∇(3 and 4):'''Cycle through the jobs or raise or lower the power, speed, or bed height
==Properties==
==Properties==