295
edits
Changes
Digital technologies/3D printing/3D modeling- Beginner (view source)
Revision as of 12:50, 19 August 2021
, 12:50, 19 August 2021→Create a New Design
===Build plate adhesion===
===Build plate adhesion===
When printing, adhesion is one of the main considerations. Make sure your design contains an adequate flat section that, if used as a base for the print, will not lead to excessive overhangs. The Thingiverse hand is a bad example the way it is positioned in '''Importing Models''' section of this article, but the way the flat section of the wrist is designed, and considering the position of the fingers not overhanging (perhaps the pinkie is slightly overhanging), placed on the its flat wrist section, this hand model is expected to print properly without the use of adhesion or even supports!
When printing, adhesion is one of the main considerations. Make sure your design contains an adequate flat section that, if used as a base for the print, will not lead to excessive overhangs. The Thingiverse hand is a bad example the way it is positioned in '''Importing Models''' section of this article, but the way the flat section of the wrist is designed, and considering the position of the fingers not significantly overhanging (perhaps the pinkie is slightly overhanging), placed on the its flat wrist section, this hand model is expected to print properly without the use of adhesion or even supports!
===Large prints===
===Large prints===