MakerRepo Staff
4
edits
Changes
mLine 30:
Line 30: + + +
Added HDR settings
When setting up a object on the turntable, make sure the object is centered on the turn table and is fully viewed by the preview of the scanner. Also verify that is it properly supported to the turntable and that it won’t slip as it turns. If it will, use some sticky tack to temporarily stick the object down.
When setting up a object on the turntable, make sure the object is centered on the turn table and is fully viewed by the preview of the scanner. Also verify that is it properly supported to the turntable and that it won’t slip as it turns. If it will, use some sticky tack to temporarily stick the object down.
=== HDR (High Dynamic Range) Settings ===
The HDR (high dynamic range) settings alter the level of contrast that the scanner will use to detect an object as it flashes light during the scans. A lower HDR won’t pick up as much contrasting details. There is a preview in the program that shows what will most likely get picked up shown in red that can be used to ensure the object being scanned is properly captured. In short, if there are more colours, a higher HDR should be chosen to ensure they all get properly scanned.