Changes

Digital technologies/PCB milling machine (view source)

Revision as of 17:22, 21 June 2024

No change in size , 21 June

Line 111: Line 111: −

# In the dialog that is displayed, you can select the template of your choice. For now, '''select''' the template DoubleSided_NoTHP.cbf in the tab Templates to create a double-sided PCB.

+

−

[[File:New document creation.png|center|New document creation|link=Special:FilePath/New_document_creation.png]]

+

4.In the dialog that is displayed, you can select the template of your choice. For now, '''select''' the template DoubleSided_NoTHP.cbf in the tab Templates to create a double-sided PCB.[[File:New document creation.png|center|New document creation|link=Special:FilePath/New_document_creation.png]]

<div class="center" style="width: auto; margin-left: auto; margin-right: auto;">Figure 6. New document creation</div>

−

The dialog will close, and the user interface will change as follows:

Line 122: Line 121: −

# Whenever the machine or the software has not been shut down properly. The last tool status is unknown. If that happens, you will be prompted to put down the tool possibly being in the collet into the corresponding tool holder.

+

5.Whenever the machine or the software has not been shut down properly. The last tool status is unknown. If that happens, you will be prompted to put down the tool possibly being in the collet into the corresponding tool holder.[[File:Tool holder prompt.png|center|Tool holder prompt|link=Special:FilePath/Tool_holder_prompt.png]]

−

[[File:Tool holder prompt.png|center|Tool holder prompt|link=Special:FilePath/Tool_holder_prompt.png]]

<div class="center" style="width: auto; margin-left: auto; margin-right: auto;">Figure 8. Tool holder prompt</div>

−

~~# Preparing the data~~

+

=== Preparing the data ===

# At this point, you should have a file that was given to you at the beginning of this workshop. '''Download''' that file and save it on your computer.

Gmang049

MakerRepo Staff, MakerRepo Volunteers

872

edits