MakerRepo Staff, MakerRepo Volunteers
872
edits
Changes
Digital technologies/Laser cutting/Tutorial: How to Laser Cut (view source)
Revision as of 15:13, 20 June 2024
, 20 June→Air compressor
==== Air compressor ====
==== Air compressor ====
This is the orange handle next to laser cutter, under the materials settings list. Turn the handle towards the ON direction (handle in-line with tube). You should hear the air start.
[[File:Air Compressor1.png|center|Air Compressor]]
The picture below shows how to turn on the laser for the Helix laser.[[File:Air Compressor1.png|center|Air Compressor]]
The picture below shows how to turn on the air compressor for the Mini laser.
[[File:Air Compressor2.png|center|Air Compressor2]]
[[File:Air Compressor2.png|center|Air Compressor2]]
==== Filter ====
==== Filter ====
[[File:Filter.png|center|Filter]]
[[File:Filter.png|center|Filter|link=Special:FilePath/Filter.png]]
The filter is activated by a little black dial that must be turned to ON. It can be found on the back wall of the Makerspace between the two windows.
The filter is activated by a little black dial that must be turned to ON. It can be found on the back wall of the Makerspace between the two windows.