MakerRepo Administrators, MakerRepo Staff
531
edits
Changes
→Recommended settings
| minLayerHeight = 0.01
| minLayerHeight = 0.01
| heatedBuildPlate = Yes
| heatedBuildPlate = Yes
|float=right
| float = right
|buildWidth=305
| moreInformation = https://en.wiki.makerepo.com/wiki/Raise3D_N2_Plus
|buildDepth=305
| buildWidth = 305
|buildHeight=605
| buildDepth = 305
|recommendedSettings=https://en.wiki.makerepo.com/wiki/Raise3D_N2_Plus}}
| buildHeight = 605
| recommendedSettings = https://en.wiki.makerepo.com/wiki/Raise3D_N2_Plus
}}
==Recommended settings==
==Recommended settings==
|120
|120
|}
|}
== Staring the print ==
To start a print on the Raise N2 Plus, your file must first be sliced in a slicer called ideaMaker. Once sliced the file must be saved on a USB stick and inserted into the side of the machine. Then a password must be entered before you can continue. Please ask a staff member for help. Finally select print and navigate the folders for your file and select print. the machine will then heat up and start printing.
[[Category:3D Printers]]
[[Category:3D Printers]]