MakerRepo Administrators, MakerRepo Staff
213
edits
Changes
Digital technologies/Laser cutting/Laser cutting- Beginner (view source)
Revision as of 01:30, 27 June 2022
, 01:30, 27 June 2022→Design Resources
**Make sure that in the Epilog Driver, the "Piece size" is bigger than the size of your document
**Make sure that in the Epilog Driver, the "Piece size" is bigger than the size of your document
==Design Resources==
==Resources==
Some programs exist to simplify the laser cutting workflow. A few tools are listed below.
Some programs exist to simplify the laser cutting workflow. A few tools are listed below.
===[https://en.makercase.com/#/ Makerbox]===
===[https://en.makercase.com/#/ Makerbox]===
===[https://knowledge.autodesk.com/support/fusion-360/downloads/caas/downloads/content/slicer-for-fusion-360.html Slicer for Fusion 360]===
===[https://knowledge.autodesk.com/support/fusion-360/downloads/caas/downloads/content/slicer-for-fusion-360.html Slicer for Fusion 360]===
Slicer for Fusion 360 is a Fusion 360 add-on that allows for the conversion of 3D models into lasercuttable puzzle-like designs. This add-on can be extremely useful at making an inner-skeleton of large structures.
Slicer for Fusion 360 is a Fusion 360 add-on that allows for the conversion of 3D models into lasercuttable puzzle-like designs. This add-on can be extremely useful at making an inner-skeleton of large structures.
=== Laser cutter Simulation ===
A simulator that shows all the steps to use the laser cutter in the Makerspace can be found in https://makerepo.com/jboud030/652.decoupe-laser-virtuel-virtual-laser-cutting
==Resources==
==Resources==
#
#
<references />
<references />