Changes

'''Tips: There are a few important safety features incorporated into the laser cutter. Placed on the glass lid is a magnetic switch. If the lid is opened while the laser is running, the lense mechanism will keep moving, but the laser will stop firing. This means that it is very difficult (if not impossible) to burn yourself with the laser. A similar mechanism is incorporated into the front door.'''

'''Tips: There are a few important safety features incorporated into the laser cutter. Placed on the glass lid is a magnetic switch. If the lid is opened while the laser is running, the lense mechanism will keep moving, but the laser will stop firing. This means that it is very difficult (if not impossible) to burn yourself with the laser. A similar mechanism is incorporated into the front door.'''

===Control Panel===

===Control Panel===

As shown in the image below, the laser cutter has an on/off located on the bottom left hand side of the laser. The main control panel located on the front.

One way for the user to interact with the laser is by using the control panel. The list below describe the properties of each button found in the laser cutter control panel.

#'''Go:'''Start or stop a job or process

#'''Go:'''Start or stop a job or process

[[File:Job Manager.png|center|thumb|469x469px|The Epilog Laser cutter dashboard|alt=]]

[[File:Job Manager.png|center|thumb|469x469px|The Epilog Laser cutter dashboard|alt=]]

===Properties===

===Properties===

#'''Resolution:'''The print resolution can set from 75 to 1200 Dots per inch(DPI).the higher the DPI the more time it takes for laser cutter to complete the job.

#'''Resolution:'''The print resolution can set from 75 to 1200 Dots per inch(DPI).the higher the DPI the more time it takes for laser cutter to complete the job.