These are the presets for the different nozzles on the Ultimaker 2+.
Ultimaker 2+
| Slicer | Cura |
|---|---|
| Build Volume | 223 × 223 × 205 mm |
| Compatible materials | PLA, ABS, Flexible |
| Minimum Layer Height | 0.06 mm |
| Heated Build Plate | Yes |
| More Information | [{{{moreInformation}}} Ultimaker 2+] |
Using 0.4 nozzle
| Low print | Normal | High | |
| Layer Height (mm) | 0.15 | 0.10 | 0.06 |
| Top/Bottom Layer thickness (mm) | 0.75 | 1.05 | 1.05 |
| Wall thickness (mm) | 0.7 | 0.8 | 0.72 |
| Infill (%) | 18 | 20 | 22 |
| Build Speed (mm/s) | 60 | 50 | 50 |
| Travel Speed (mm/s) | 150 | 120 | 120 |
Using 0.6 Nozzle
| Normal | |
| Layer Height (mm) | 0.15 |
| Top/Bottom Layer thickness (mm) | 1.2 |
| Wall thickness (mm) | 1.59 |
| Infill (%) | 20 |
| Build Speed (mm/s) | 55 |
| Travel Speed (mm/s) | 120 |
Using 0.8 Nozzle
| Low | |
| Layer Height (mm) | 0.2 |
| Top/Bottom Layer thickness (mm) | 1.2 |
| Wall thickness (mm) | 2.1 |
| Infill (%) | 20 |
| Build Speed (mm/s) | 40 |
| Travel Speed (mm/s) | 120 |