Dremel 3D20

Revision as of 18:28, 4 June 2024 by Kaily (talk | contribs)
Dremel 3D20
Dremel-3D20.png
Slicer DigiLab 3D
Build Volume 230 × 150 × 140 mm
Compatible materials PLA
Minimum Layer Height 0.1 mm
Heated Build Plate No
More Information [{{{moreInformation}}} Dremel 3D20]

Start the print

Starting your print is very simple. Simply save your file to an SD card or connect your computer to the printer and click print or build.

Dremel

If you are using a USB cord, the print with start automatically when you hit build in on your computer. Follow the following step if you are using the SD card.

  1. Place your SD card in the SD card slot in the 3D printing. This is found on the right hand side near the front of the printer.
  2. If the 3D printer is not already on, turn on the printer using the on/off switch located at the right hand side near the back of the printer.
  3. Using the front screen, press build ->The picture of an SD card ->select your file -> Build.