Difference between revisions of "Markforged Mark Two"
Jump to navigation
Jump to search
m |
|||
| Line 9: | Line 9: | ||
| heatedBuildPlate = No | | heatedBuildPlate = No | ||
|float=right|buildWidth=320|buildDepth=132|buildHeight=154|recommendedSettings=https://en.wiki.makerepo.com/wiki/Markforged_Mark_Two}} | |float=right|buildWidth=320|buildDepth=132|buildHeight=154|recommendedSettings=https://en.wiki.makerepo.com/wiki/Markforged_Mark_Two}} | ||
| − | + | ==recommended settings== | |
| + | {| class="wikitable" | ||
| + | | | ||
| + | |Normal | ||
| + | |- | ||
| + | |Layer Height (mm) | ||
| + | |0.15 | ||
| + | |- | ||
| + | |Top/Bottom Layer thickness (mm) | ||
| + | |1.2 | ||
| + | |- | ||
| + | |Wall thickness (mm) | ||
| + | |1.59 | ||
| + | |- | ||
| + | |Infill (%) | ||
| + | |20 | ||
| + | |- | ||
| + | |Build Speed (mm/s) | ||
| + | |55 | ||
| + | |- | ||
| + | |Travel Speed (mm/s) | ||
| + | |120 | ||
| + | |} | ||
[[Category:3D Printers]] | [[Category:3D Printers]] | ||
Revision as of 19:10, 4 June 2024
Markforged Mark Two
| Slicer | Eiger |
|---|---|
| Build Volume | 320 × 132 × 154 mm |
| Compatible materials | Nylon, Onyx, Carbon Fiber, Fiberglass, Kevlar |
| Minimum Layer Height | 0.1 mm |
| Heated Build Plate | No |
| More Information | [{{{moreInformation}}} Markforged Mark Two] |
recommended settings
| Normal | |
| Layer Height (mm) | 0.15 |
| Top/Bottom Layer thickness (mm) | 1.2 |
| Wall thickness (mm) | 1.59 |
| Infill (%) | 20 |
| Build Speed (mm/s) | 55 |
| Travel Speed (mm/s) | 120 |