Difference between revisions of "Ultimaker 2+"

From CEED Wiki
Jump to navigation Jump to search
m
Line 1: Line 1:
 +
== Recommended Settings ==
 
{{PrinterInfobox
 
{{PrinterInfobox
 
| name = Ultimaker 2+
 
| name = Ultimaker 2+
Line 94: Line 95:
 
|120
 
|120
 
|}
 
|}
 +
 +
== Staring the print ==
 +
To start a print on the Ultimaker 2+ you will first need an SD card to upload your files to the printer. These can be requested from the front desk after you sign out a printer. For the Ultimaker 2+ the slicer to use is Cura. Once you have your model sliced in Cura, insert the SD card into your computer. This should add the option to "save to removable disk" ad the bottom left of Cura. Once your file is on the SD card go to the printer and insert the card. If the machine is on, rotate the dial until "print" is highlighted, then push the dial in. This will open the SD card and from this menu you can choose your file. To chose, press the dial in again and the printer will heat up and start printing.
 
[[Category:3D Printers]]
 
[[Category:3D Printers]]

Revision as of 18:37, 4 June 2024

Recommended Settings

Ultimaker 2+
Ultimaker2+.png
Slicer Cura
Build Volume 223 × 223 × 205 mm
Compatible materials PLA, ABS, Flexible
Minimum Layer Height 0.06 mm
Heated Build Plate Yes
More Information [{{{moreInformation}}} Ultimaker 2+]

These are the presets for the different nozzles on the Ultimaker 2+.

Using 0.4 nozzle

Low print Normal High
Layer Height (mm) 0.15 0.10 0.06
Top/Bottom Layer thickness (mm) 0.75 1.05 1.05
Wall thickness (mm) 0.7 0.8 0.72
Infill (%) 18 20 22
Build Speed (mm/s) 60 50 50
Travel Speed (mm/s) 150 120 120

Using 0.6 Nozzle

Normal
Layer Height (mm) 0.15
Top/Bottom Layer thickness (mm) 1.2
Wall thickness (mm) 1.59
Infill (%) 20
Build Speed (mm/s) 55
Travel Speed (mm/s) 120

Using 0.8 Nozzle

Low
Layer Height (mm) 0.2
Top/Bottom Layer thickness (mm) 1.2
Wall thickness (mm) 2.1
Infill (%) 20
Build Speed (mm/s) 40
Travel Speed (mm/s) 120

Staring the print

To start a print on the Ultimaker 2+ you will first need an SD card to upload your files to the printer. These can be requested from the front desk after you sign out a printer. For the Ultimaker 2+ the slicer to use is Cura. Once you have your model sliced in Cura, insert the SD card into your computer. This should add the option to "save to removable disk" ad the bottom left of Cura. Once your file is on the SD card go to the printer and insert the card. If the machine is on, rotate the dial until "print" is highlighted, then push the dial in. This will open the SD card and from this menu you can choose your file. To chose, press the dial in again and the printer will heat up and start printing.