Difference between revisions of "Markforged Mark Two"
Jump to navigation
Jump to search
(Created page with "{{PrinterInfobox | name = Markforged Mark Two | image = Mk2.png | slicerName = Eiger | slicerLink = https://www.eiger.io/signin | buildVolume = 320 × 132 × 154 mm | mat...") |
|||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 8: | Line 8: | ||
| minLayerHeight = 0.1 | | minLayerHeight = 0.1 | ||
| heatedBuildPlate = No | | heatedBuildPlate = No | ||
| − | |float= | + | | float = right |
| + | | moreInformation = https://en.wiki.makerepo.com/wiki/Markforged_Mark_Two | ||
| + | | buildWidth = 320 | ||
| + | | buildDepth = 132 | ||
| + | | buildHeight = 154 | ||
| + | }} | ||
| + | ==Recommended settings== | ||
| + | {| class="wikitable" | ||
| + | | | ||
| + | |Normal | ||
| + | |- | ||
| + | |Layer Height (mm) | ||
| + | |0.15 | ||
| + | |- | ||
| + | |Top/Bottom Layer thickness (mm) | ||
| + | |1.2 | ||
| + | |- | ||
| + | |Wall thickness (mm) | ||
| + | |1.59 | ||
| + | |- | ||
| + | |Infill (%) | ||
| + | |20 | ||
| + | |- | ||
| + | |Build Speed (mm/s) | ||
| + | |55 | ||
| + | |- | ||
| + | |Travel Speed (mm/s) | ||
| + | |120 | ||
| + | |} | ||
| + | == Starting the print == | ||
| + | To start a print on the Mark 2, go to the white computer beside the door and start up Eiger. After importing your files, slice and upload them to the printer. | ||
[[Category:3D Printers]] | [[Category:3D Printers]] | ||
Latest revision as of 19:14, 4 June 2024
Markforged Mark Two
| Slicer | Eiger |
|---|---|
| Build Volume | 320 × 132 × 154 mm |
| Compatible materials | Nylon, Onyx, Carbon Fiber, Fiberglass, Kevlar |
| Minimum Layer Height | 0.1 mm |
| Heated Build Plate | No |
| More Information | Markforged Mark Two |
Recommended settings
| Normal | |
| Layer Height (mm) | 0.15 |
| Top/Bottom Layer thickness (mm) | 1.2 |
| Wall thickness (mm) | 1.59 |
| Infill (%) | 20 |
| Build Speed (mm/s) | 55 |
| Travel Speed (mm/s) | 120 |
Starting the print
To start a print on the Mark 2, go to the white computer beside the door and start up Eiger. After importing your files, slice and upload them to the printer.