Changes

=== Start cut ===

=== Start cut ===

# Make sure that the glass cover is down and that you have prepare the laser. Check that your job is set on displayed on the laser cutter.

# Make sure that the glass cover is down and that you have prepared the laser. Check that your job is set on the display of the laser cutter.

# Press the green go.

# Press the green button, Go.

# While the laser cutter is cutting, do not leave the laser cutter unattended. If small flames appear, '''do not panic.''' As long as you piece is not actively burning, you are ok. If at any point you are unsure, pause your cut and find the Makerspace Coordinator on duty. You can pause your cut by pressing the red stop button, it will always finish the line that is cutting before it ends. If it needs to be stopped for safety purposes and it is not stopping with the Red Button, use the On/Off switch on the left side of the laser. Leave the lid closed. To resume, press the green go button.

# While the laser cutter is cutting, do not leave the laser cutter unattended. If small flames appear, '''do not panic.''' As long as you piece is not actively burning, you are ok. If at any point you are unsure, pause your cut and find the Makerspace Coordinator on duty. You can pause your cut by pressing the red button, Stop, it will always finish the line that is cutting before it ends. If it needs to be stopped for safety purposes and it is not stopping with the Red Button, use the On/Off switch on the left side of the laser. Leave the lid closed. To resume, press the green button, Go.

=== Turn off laser cutter setup ===

=== Turn off laser cutter setup ===

When you are finished all your cuts, turn off the laser cutter, air compressor, and air filter.

When you are finished all your cuts, turn off the laser cutter, the air compressor, the air filter and disconnect the extension cord from the electrical outlet.

=== Clean up<ref name=":0" /> ===

=== Clean up<ref name=":0" /> ===