Markforged Mark Two: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 8: | Line 8: | ||
| minLayerHeight = 0.1 | | minLayerHeight = 0.1 | ||
| heatedBuildPlate = No | | heatedBuildPlate = No | ||
|float=right|buildWidth=320|buildDepth=132|buildHeight=154| | | float = right | ||
| moreInformation = https://en.wiki.makerepo.com/wiki/Markforged_Mark_Two | |||
| buildWidth = 320 | |||
| buildDepth = 132 | |||
| buildHeight = 154 | |||
}} | |||
==Recommended settings== | |||
{| class="wikitable" | |||
| | |||
|Normal | |||
|- | |||
|Layer Height (mm) | |||
|0.15 | |||
|- | |||
|Top/Bottom Layer thickness (mm) | |||
|1.2 | |||
|- | |||
|Wall thickness (mm) | |||
|1.59 | |||
|- | |||
|Infill (%) | |||
|20 | |||
|- | |||
|Build Speed (mm/s) | |||
|55 | |||
|- | |||
|Travel Speed (mm/s) | |||
|120 | |||
|} | |||
== Starting the print == | |||
To start a print on the Mark 2, go to the white computer beside the door and start up Eiger. After importing your files, slice and upload them to the printer. | |||
[[Category:3D Printers]] | [[Category:3D Printers]] | ||
Latest revision as of 19:14, 4 June 2024
Markforged Mark Two
| Slicer | Eiger |
|---|---|
| Build Volume | 320 × 132 × 154 mm |
| Compatible materials | Nylon, Onyx, Carbon Fiber, Fiberglass, Kevlar |
| Minimum Layer Height | 0.1 mm |
| Heated Build Plate | No |
| More Information | Markforged Mark Two |
Recommended settings
| Normal | |
| Layer Height (mm) | 0.15 |
| Top/Bottom Layer thickness (mm) | 1.2 |
| Wall thickness (mm) | 1.59 |
| Infill (%) | 20 |
| Build Speed (mm/s) | 55 |
| Travel Speed (mm/s) | 120 |
Starting the print
To start a print on the Mark 2, go to the white computer beside the door and start up Eiger. After importing your files, slice and upload them to the printer.