Difference between revisions of "Dremel 3D20"
Jump to navigation
Jump to search
m |
|||
| Line 9: | Line 9: | ||
| heatedBuildPlate = No | | heatedBuildPlate = No | ||
|float=right|buildWidth=230|buildDepth=150|buildHeight=140|recommendedSettings=https://en.wiki.makerepo.com/wiki/Dremel_3D20}} | |float=right|buildWidth=230|buildDepth=150|buildHeight=140|recommendedSettings=https://en.wiki.makerepo.com/wiki/Dremel_3D20}} | ||
| + | ===Start the print=== | ||
| + | Starting your print is very simple. Simply save your file to an SD card or connect your computer to the printer and click print or build. | ||
| − | + | '''Dremel''' | |
| + | |||
| + | If you are using a USB cord, the print with start automatically when you hit build in on your computer. Follow the following step if you are using the SD card. | ||
| + | #Place your SD card in the SD card slot in the 3D printing. This is found on the right hand side near the front of the printer. | ||
| + | #If the 3D printer is not already on, turn on the printer using the on/off switch located at the right hand side near the back of the printer. | ||
| + | #Using the front screen, press build ->The picture of an SD card ->select your file -> Build. | ||
[[Category:3D Printers]] | [[Category:3D Printers]] | ||
Revision as of 18:28, 4 June 2024
Dremel 3D20
| Slicer | DigiLab 3D |
|---|---|
| Build Volume | 230 × 150 × 140 mm |
| Compatible materials | PLA |
| Minimum Layer Height | 0.1 mm |
| Heated Build Plate | No |
| More Information | [{{{moreInformation}}} Dremel 3D20] |
Start the print
Starting your print is very simple. Simply save your file to an SD card or connect your computer to the printer and click print or build.
Dremel
If you are using a USB cord, the print with start automatically when you hit build in on your computer. Follow the following step if you are using the SD card.
- Place your SD card in the SD card slot in the 3D printing. This is found on the right hand side near the front of the printer.
- If the 3D printer is not already on, turn on the printer using the on/off switch located at the right hand side near the back of the printer.
- Using the front screen, press build ->The picture of an SD card ->select your file -> Build.