MakerRepo Staff, MakerRepo Volunteers
240
edits
Changes
Jump to navigation
Jump to search
Line 154:
Line 154: − +
Digital technologies/Soldering/Soldering- Beginner (view source)
Revision as of 18:32, 22 July 2022
, 18:32, 22 July 2022→Procedure
#Grab a few wires, strip 1 cm off each end and bend each end in a U shape.
#Grab a few wires, strip 1 cm off each end and bend each end in a U shape.
#Crimp the two wires together with a pair of pliers.
#Twist the two wires together with plier or your fingers.
#Hold the soldering iron like a pen. Heat the two wires for 1-2 seconds and then flow solder on the connection. The goal is to heat the connection not the solder. Once you see the solder flow evenly throughout the connection, remove the solder and soldering iron.
#Hold the soldering iron like a pen. Heat the two wires for 1-2 seconds and then flow solder on the connection. The goal is to heat the connection not the solder. Once you see the solder flow evenly throughout the connection, remove the solder and soldering iron.
#Allow the connection to cool, this usually takes 20-30 seconds. During this time, avoid moving the wires
#Allow the connection to cool, this usually takes 20-30 seconds. During this time, avoid moving the wires